With the rapid development of science and technology, circuit boards are becoming more and more sophisticated, and cutting requirements are very high. Many SMT factories must use milling cutter board splitters to cut circuit boards. Before starting the machine, you must do these preparations. Otherwise, it will directly lead to the service life of the pcba milling cutter board splitter, and in severe cases, it will cause the milling cutter pcba board splitter to be directly scrapped. Please be sure to read it carefully and take good care of the board splitter equipment, just like taking care of your car.

[Preparation steps] Preparation steps for the operation process of the pcb milling cutter board splitter:

1. Check the peripheral environment of the pcb milling cutter board splitter, whether there are abnormal phenomena such as water accumulation in the electrical box and filter, and whether each motion axis is movable.

2. Start the machine step by step: Before starting the machine, you must check whether the input power supply voltage of the equipment is missing or too low. After the power is turned on for about 10 minutes and the voltage is stable, you can turn on the power switch of the equipment and observe whether there are any abnormal phenomena or air leaks. If there is no alarm when starting the machine, do not perform any actions, and let the electrical components be powered on for 30 minutes.

3. Slow movement: Check for interference and pay attention to any abnormal phenomena, then perform the origin reset step.

4. Equipment running-in: Automatically run the pcb milling cutter board splitter at a slow speed for a long time, and rotate the spindle at a low speed for 30 minutes.

After completing the above 4 steps, the pcb milling cutter board splitter equipment can start debugging and production.

In the next issue, I will explain to you how to adjust the program of our Zhimao brand milling cutter board splitter when it is turned on. After the board splitter program is debugged, it can be automatically generated without manual supervision. Even if there are minor problems, it will be automatically corrected and continue normal production. Choose Zhimao brand milling cutter board splitter for worry-free production!

(This article is originally created by Zhimao fully automatic PCBA board splitter manufacturer. Reprinting must indicate the source: www.dg-genitec.com. Please respect the fruits of labor and copyright infringement will be investigated!)